Pioneer DEH-P9850BT Car Stereo System User Manual


 
Black plate (10,1)
Feature demo mode
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing
DISPLAY during feature demo operation can-
cels the feature demo mode. Press DISPLAY
again to start the feature demo mode. Remem-
ber that if the feature demo continues operat-
ing when the car engine is turned off, it may
drain battery power.
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus () poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out ofthe reach of children.
Should the battery beswallowed, immediately
consult a doctor.
CAUTION
! Use only oneCR2025 (3 V) lithiumbattery.
! Remove thebattery if the remotecontrol is not
used for amonth or longer.
! Do not recharge, disassemble, heat ordispose
of the battery in fire.
! Do not handlethe battery with metallic tools.
! Do not storethe battery with metallicmateri-
als.
! In the eventof battery leakage, wipethe re-
mote control completelyclean and install a
new battery.
! When disposing ofused batteries, please
comply with governmental regulationsor en-
vironmental public institutionsrulesthat
apply in yourcountry/area.
Using the remote control
Point the remote control in the direction of the
front panel to operate.
! The remote control may not function prop-
erly in direct sunlight.
Important
! Do not storethe remote control inhigh tem-
peratures or directsunlight.
! Do not letthe remote control fallonto the
floor, where it maybecome jammed underthe
brake or accelerator pedal.
FUNCTION button and AUDIO button
You can also select the desired mode by
FUNCTION button and AUDIO button on the
remote control. But operation of FUNCTION
button and AUDIO button on the remote con-
trol differs from the operation of
MULTI-CONTROL on the head unit. When op-
erating the remote control, switch through the
modes as described below to select the mode.
FUNCTION button operation
% Press FUNCTION to select the desired
mode (e.g., built-in CD player).
Press FUNCTION repeatedly to switch be-
tween the following modes:
<CRB2179-A/N>10
Before You Start
En
10
Section
01