Filter
Top Products
Black plate (87,1)
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1 Use MULTI-CONTROL to select
Reverse mode.
Reverse mode appears in the display.
2 Press MULTI-CONTROL to turn the re-
verse mode on.
ON appears in the display.
# To turn the reversemode off, press
MULTI-CONTROL again.
Note
You canalso turn on oroff reverse mode bypress-
ing BAND whilethis unit is turnedoff. For more
details, see Reverse modeon page 9.
Switching the Ever Scroll
When Ever Scroll is set to ON, CD text infor-
mation scrolls continuously in the display. Set
to OFF if you prefer the information to scroll
just once.
1 Use MULTI-CONTROL to select
Ever-scroll.
Ever-scroll appears in the display.
2 Press MULTI-CONTROL to turn the Ever
Scroll on.
ON appears in the display.
# To turn the EverScroll off, press
MULTI-CONTROL again.
Calibrating the RPMs
Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer of this unit cannot work if you
do not perform the RPM calibration.
! In some vehicles, the tachometer may not
work properly even if you performed the
RPM calibration.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Use MULTI-CONTROL to select
Calibration.
Calibration appears in the display.
3 Keep RPMs of the engine at 4000 rpm
and press MULTI-CONTROL.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4000 rpm for a
few seconds.
When the RPM calibration is completed,
Completed is displayed.
# Some vehicles havea rev limiter thatkicks in
early (e.g., 3000rpm) while parking.In this case,
perform RPM measurement at2000 rpm.
# To switch between4000 rpm and 2000rpm,
push MULTI-CONTROL left or right.
Activating the BT Audio source
You need to activate the BTAudio source in
order to use a Bluetooth audio player.
1 Use MULTI-CONTROL to select
BTAUDIO.
BTAUDIO appears in the display.
<CRB2179-A/N>87
Initial Settings
En
87
English
Section
14