Filter
Top Products
2 Use MULTI-CONTROL to select
CONNECTION.
The connection menu is displayed.
Turn to change the menu option. Press to se-
lect.
3 Turn MULTI-CONTROL to select the
function.
PAIRED PHONE (paired phone)—
BT HANDS FREE (new phone)—SET PHONE
(phone registration)—DISCONNECT PHONE
(disconnect phone)—DELETE PHONE (delete
phone)
If the phone is not connected and not
paired
The following function can be operated.
! BT HANDS FREE (new phone)
If the phone is not connected but paired
The following functions can be operated.
! PAIRED PHONE (pair phone manually)
! BT HANDS FREE (new phone)
! DELETE PHONE (delete phone)
If the phone is connected but not paired
The following functions can be operated.
! SET PHONE (phone registration)
! DISCONNECT PHONE (disconnect phone)
! DELETE PHONE (delete phone)
If the phone is connected and paired
The following functions can be operated.
! DISCONNECT PHONE (disconnect phone)
! DELETE PHONE (delete phone)
Connecting and disconnecting
a cellular phone
Using a cellular phone to initiate a
connection
1 Display the connection menu.
Refer to Introduction to connection and pairing
on the previous page.
2 Use MULTI-CONTROL to select
BT HANDS FREE.
3 Use MULTI-CONTROL to select a group.
Push MULTI-CONTROL up or down to select a
group.
NOKIA (Nokia)—STANDARD (standard)
# Normally select STANDARD. If thedevice of
Nokia is not paired to this unit, select NOKIA.
# Push MULTI-CONTROL left orright to display
a group nameor an ID.
4 Press MULTI-CONTROL to switch to
PAIR FROM PHONE.
Push MULTI-CONTROL up or down to switch
PAIR FROM PHONE and SEARCH DEVICE.
5 Select PAIR FROM PHONE and then
press MULTI-CONTROL to ready for pairing.
READY will be displayed.
6 Use your cellular phone to establish
connection.
PIN code is set to 0000 as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection on page 51.
While connecting, CONNECTING is displayed.
If the connection is established, COMPLETED
is displayed.
After connected, this unit automatically
changes to PH.BOOK DL (phone book down-
load confirmation) display.
# If the connectionfails, ERROR is displayed. In
this case, check the cellular phone and try again.
# If three cellular phones have already been
paired, the pairing assignment selection display
will appear. Select one assignment to pair the
new phone. The newly paired phone overwrites
the previously paired phone.The assignment se-
lection operation is the same as Step 3 to 4 of
Pairing a connected cellular phone on page 33 ex-
cept for the operation below.
! Switching the BD address and device name
7 Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push MULTI-CONTROL left or right to select
NO (No) or YES (Yes).
Press MULTI-CONTROL to decide.
Operating this unit
En
31
Section
02
Operating this unit