Filter
Top Products
3 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time MULTI-CONTROL is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
50HZ—125HZ—315HZ—800HZ—2KHZ—
5KHZ—12.5KHZ
4 Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time MULTI-CONTROL is pushed up or
down, the level of the equalization band in-
creases or decreases.
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
5 Press BAND to cancel the 7-band gra-
phic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 44.
2 Use MULTI-CONTROL to select
LOUDNESS.
3 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g., MID) appears in the dis-
play.
# To turn loudness off, press MULTI-CONTROL
again.
4 Push MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pushed left or
right, level is selected in the following order:
LOW (low)—MID (mid)—HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 44.
2 Use MULTI-CONTROL to select SUB W1.
3 Press MULTI-CONTROL to turn subwoo-
fer output on.
NORMAL appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press
MULTI-CONTROL again.
4 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and REVERSE appears in the display.
Push MULTI-CONTROL right to select normal
phase and NORMAL appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
! When the subwoofer output is on, you can
select SUB W2.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
page 44.
2 Use MULTI-CONTROL to select SUB W2.
3 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50HZ—63HZ—80HZ—100HZ—125HZ
Audio Adjustments
En
46
Section
03