Filter
Top Products
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
! Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3 Turn MULTI-CONTROL to select one of
the initial settings.
Turn MULTI-CONTROL to switch between the
functions in the following order.
CALENDAR (calendar)—CLOCK (clock)—
AUX1 (auxiliary input 1)—AUX2 (auxiliary
input 2)—DIMMER (dimmer)—
S/W CONTROL (rear output and subwoofer
controller)—MUTE (sound muting/attenua-
tion)—BUILT-IN AMP (power amp setting)—
DEMONSTRATION (feature demo)—
EVER-SCROLL (ever scroll)—BTAUDIO (Blue-
tooth audio)—PIN CODE INPUT (pin code
input)—EDIT DEVICE NAME (device name
edit)—BT VERSION INFO. (Bluetooth version
information)—BT RESET (Bluetooth reset)—
SOFTWARE UPDATE (software update)
Use the following instructions to operate each
particular setting.
# You can also select the function by pressing
FUNCTION on the remote control.
# To cancel initial settings, press BAND.
Setting the date
The calender display adjusted in this mode ap-
pears when the telephone source is selected
or sources and the feature demo are off.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select
CALENDAR.
3 Push MULTI-CONTROL left or right to
select the segment of the calendar display
you wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the calendar display:
Day—Month—Year
As you select segments of the calendar dis-
play the segment selected will blink.
4 Push MULTI-CONTROL up or down to
set the date.
Pushing MULTI-CONTROL up will increase
the selected day, month or year. Pushing
MULTI-CONTROL down will decrease the se-
lected day, month or year.
Setting the clock
Use these instructions to set the clock.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select CLOCK.
3 Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing MULTI-CONTROL left or right will se-
lect one segment of the clock display:
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
4 Push MULTI-CONTROL up or down to
put a clock right.
Initial Settings
En
48
Section
04