Filter
Top Products
FCC ID: AJDK029
MODEL NO.: MVH-P8200BT
IC: 775E-K029
This equipment complies withFCC/IC radiation
exposure limits set forth for uncontrolled
equipment and meets the FCC/IC radio fre-
quency (RF) Exposure Guidelines in Supple-
ment C to OET65. This equipment has very low
levels of RFenergy that it deemed to comply
without maximum permissive exposureevalua-
tion (MPE). But it is desirable that it shouldbe
installed and operated with at least 20cm and
more between the radiator and person’s body
(excluding extremities: hands, wrists,feet and
ankles).
This transmitter must not be co-located or oper-
ated in conjunction with any other antennaor
transmitter.
MVH-P8200
This device complies with part 15 of the FCC
Rules. Operation is subjectto the following
two conditions:
(1) This device may not cause harmfulinterfer-
ence, and (2) this device must accept anyinter-
ference received, including interference that
may cause undesired operation.
Information to User
Alteration or modifications carried outwithout
appropriate authorization may invalidate the
user’s right to operate the equipment.
For Canadian model
This Class B digital apparatus complies with
Canadian ICES-003.
About this unit
The tuner frequencies on this unit are allo-
cated for use in North America. Use in other
areas may result in poor reception.
WARNING
Handling the cord on this product or cordsasso-
ciated with accessories sold with the product
may expose you to chemicals listed on proposi-
tion 65 known to the State of California and other
governmental entities to cause cancerand birth
defect or other reproductive harm. Wash hands
after handling..
CAUTION
! Do not allow this unit to come into contact
with liquids. Electrical shock could result.
Also, damage to this unit, smoke,and over-
heating could result from contact withliquids.
! Keep this manual handy for future reference.
! Always keep the volume low enough tohear
outside sounds.
! Avoid exposure to moisture.
! If the battery is disconnected or discharged,
any preset memory will be erased.
Important (Serial number)
The serial number is located on the bottomof
this unit. For your ownsecurity and convenience,
be sure to record this number on the enclosed
warranty card.
Operating environment
This unit should be used within the tempera-
ture ranges shown below.
Operating temperature range: -10 °C to +60 °C
(14 °F to 140 °F)
EN300328 ETC test temperature: -20 °C and
+55 °C (-4 °Fand 131 °F)
En
6
Section
02
Before You Start