Filter
Top Products
This unit features a function that automatically
switches to the rear view camera video (BACK
UP CAMERA IN jack) when a rear view cam-
era is installed on your vehicle. When the gear
shift is in REVERSE (R) position, the video
automatically switches to a rear view camera
video. (For more details, consult your dealer.)
! After you set up the rear view camera set-
ting, move the gear shift in REVERSE (R)
and confirm if a rear view camera video
can be shown on the display.
! If the display should be switched to a rear
view camera video by error while you are
driving forward, change the rear view cam-
era setting.
! To end watching a rear view camera video
and return to the source display, press and
hold V.ADJUST.
1 Touch BACK UP CAMERA IN on the
setup menu to turn rear view camera set-
ting on.
# To turnrear view camerasetting off, touch
BACK UP CAMERA INagain.
2 Touch B. CAMERA POLARITY on the
setup menu to select an appropriate set-
ting for polarity.
Each time you touch B. CAMERA POLARITY it
switches between the following polarity:
! BATTERY – When the polarityof the con-
nected lead is positive while the gear shift
is in REVERSE (R)position
! GROUND – When thepolarity of the con-
nected lead is negativewhile the gear shift
is in REVERSE (R)position
Setting the automatic open
function
To prevent the display from hitting the shift
lever of an automatic vehicle when it is in P
(park) position, or when you do not wish the
display to open/close automatically, you can
set the automatic open function in the manual
mode.
% Touch AUTO FLAP on the setup menu
to select the display to open/close automa-
tically or manually.
Each time you touch AUTO FLAP it switches
between the following settings:
! AUTO – The LCDpanel will be opened or
closed automatically withthe turning of the
ignition switch onor off
! MANUAL – You haveto press
OPEN/CLOSE to open/closethe LCD
panel
Adjusting the LCD panel
slide position
You can adjust the LCD panel slide position so
that the panel is set back or forward.
% Touch FLAP SET BACK on the setup
menu to turn the set back on.
The LCD panel slides to the back.
# Touch FLAPSET BACK again to turn theset
back off andthe LCD panel slides to thefront.
Setting the clock
Use these instructions to set the clock.
1 Touch CLOCK ADJUSTMENT on the
setup menu.
2 Touch 0—9 to set the clock.
# To cancelthe inputted numbers, touch C.
3 Touch ENTER.
Setup
En
110
Section
21