Filter
Top Products
37
Before wiring and installation
■ Transport Lock Screws
The mechanism in the changer is “locked” into
place during shipment by the transport screws.
Be sure to remove the screws prior to installation.
Note:
After removing the transport lock screws, place the supplied seals (A) over the screw
holes. Also, place the seals (A) over the holes which are not used for installation.
These seals are used to keep dust, which could cause a malfunction, out of the
unit.
■ Installation and Wiring Precautions
1 To prevent a short-circuit,
¡ Be sure to turn off the ignition and remove the negative (–) battery cable prior to
installation.
Note:
If the changer is to be installed in a car that is equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is
disconnected, the computer memory may be lost. Under these conditions, use
extra caution to avoid causing a short circuit during installation.
2 Do not install the unit in the following locations.
¡ Locations exposed to direct sunlight.
¡ Where hot air is discharged from the car heater.
¡ When proper installation is not possible and
where a great deal of vibration is generated.
3 ¡ Be sure to use the supplied brackets and screws.
¡ When installing the unit, do not use any screws that are part of the brake or
steering system.
4 This unit cannot be installed in any way except that which is authorized (on its
side, on its end, at a 45° angle or suspended). Installing it with its side facing down
or upside down can cause malfunctioning.
■ Position of the built-in anti-vibration boards
This unit can be installed horizontally (suspended), vertically, and at a 45° angle.
Once the installation position has been decided, it’s necessary to set the position
of the built-in anti-vibration boards inside the unit. Please do this before
performing the procedure listed below. Vibration may cause the disc to skip if the
unit is used before properly setting the anti-vibration boards.
¡At the time of shipping, the built-in anti-vibration boards are set for horizontal
installation “H”.
¡There are 2 built-in anti-vibration boards on each side.
¡Set the anti-vibration board position with a Philips screwdriver or similar fine-
tipped implement before attaching the brackets.
Seals (A)
For use when unit is installed horizontally or suspended:
Confirm that 4 built-in anti-vibration boards
are set to position “H”.
For use when unit is installed vertically:
4 built-in anti-vibration boards should be set
to position “V”.
For use when unit is installed at a 45° angle:
4 built-in anti-vibration boards should be set to
position “45°”.
Note:
After setting the built-in anti-vibration boards, place the supplied seals (B) over the
holes. These seals are used to keep dust, which could cause a malfunction, out of
the unit.
H
V
45°
H
V
45°
H
V
45°
H
V
45°
45°
H
V
45°
H
V
45°
position “H”
position “V”
position “45°”
DV-S100/ZA(GB) 03.11.28 1:19 PM ページ37