39
Basic connection 2
When your car stereo is SANYO CD or CD/Cassette Receiver with CD Changer
Control model, attached FM modulator is not necessary.
Other connection (Example 1)
When your car stereo has RCA line-in terminals.
Wiring (2)
Attached DIN
cable (8 pin, 5 m)
Attached parking brake cable
Connect to car’s parking brake line.
Bright green
Red
White
Not used.
Yellow
(Rear)
Yellow
(Front)
Monitor with Video input jack
Monitor with Video input jack
To video input
(Yellow)
To video input
(Yellow)
* You can add a monitor for rear seats.
Attached
Remote control
sensor
R
L
SANYO CD or CD/Cassette Receiver
with CD Changer Control model
To DIN Socket
Bright green
Changer unit
If not long enough, use the
extension cable included.
Attached DIN
cable (8 pin, 5 m)
Attached parking brake cable
Connect to car's parking brake line.
Bright green
Red
White
To RCA line-in
terminals
Car stereo with
RCA line-in
terminals
Yellow
(Rear)
Changer unit
Yellow
(Front)
Monitor with Video input jack
Monitor with Video input jack
To video input
(Yellow)
To video input
(Yellow)
* You can add a monitor for rear seats.
Attached
Remote control
sensor
R
L
+12 volt Accessory/Switched (red)
Connect to where the power is
supplied when the ACC power or
ignition switch is turned ON.
+12 volt Constant (yellow)
Connect this lead to the cable to
which power is continuously supplied
and which has been passed through
the car’s fuse unit.
Ground (black)
Screw this to a metal part of the
car.
Fuse 5A
Not used.
Not used.
Attached FM
modulator
Bright green
If not long enough, use the
extension cable included.
* If a fuse becomes blown, replace it with a fuse with the correct rated capacity.
zSee page 38, “ Replacing the fuses ”.
DV-S100/ZA(GB) 03.11.28 1:19 PM ページ39