Filter
Top Products
43
Attempting to play a DVD other
than one with a region number of
“2” or “ALL”.
The audiovisual restriction
function is operative and the unit
is prohibiting DVD play.
The command is not available for
the DVD in play.
The command is not available on
the screen displayed.
Attempting to play a disc that the
unit cannot play.
Disc loaded upside down.
Dirty disc.
Moisture on the laser lens of unit.
All of the discs in the magazine
are discs that the unit cannot
play.
A magazine has not been
inserted in the unit.
There are no discs at all in the
magazine.
The region number of the unit is
“2”. DVDs with a region number
other than “2” or “ALL” cannot be
played in the unit.
Check the parental level settings
in the setup. Change the parental
level in the unit to match the
parental level of the DVD you are
trying to play, and the disc can
then be played.
A DVD can prohibit certain
operations as the disc maker
desires.
When the screen advances, the
command will become functional.
Use a disc that the unit can play.
Load disc properly.
Clean disc.
Remove the magazine from the
unit and wait about one hour.
Use a disc that the unit can play.
Insert a magazine in the unit.
Insert a disc in the magazine.
Message Cause Remedy Page
“ This disc
can’t be
played.”
“ You can’t
operate this
command
now.”
“This disc can’t
be played.”
“All discs can’t
be played.”
“Magazine is
not loaded.”
“Magazine
empty”
Blown fuse
Improper connection
Direction in which it is inserted is
wrong.
A disc is not inserted or is
inserted upside-down.
The disc is dirty.
The car battery voltage is low.
A disc that the unit cannot play is
inserted.
A DVD of a region number that
the unit cannot play is inserted.
The audiovisual restriction
function is operative and the unit
is prohibiting DVD play.
The disc recorded in PAL format
is insered when the TV signal
format switch of the unit is set to
“NTSC” position.
The disc recorded in NTSC
format is inserted when the TV
signal format switch of the unit is
set to “PAL” position.
The disc in play prohibits the
operation.
Adjustment of brightness, tone,
or color depth is poor.
Replace with a properly-rated
fuse. If the fuse blows again,
consult with your dealer.
Check connections.
Insert it in proper direction.
Insert the disc properly, with the
play side up.
Clean any debris from the disc.
Charge the battery. If the unit still
does not function, consult your
dealer.
Insert a disc that the unit can
play.
The region number of the unit is
“2”. Use a DVD with a region
number of “2” or “ALL”.
Check the parental level settings
in the setup.
Change the position of the TV
signal format switch depending
on the disc’s TV signal format.
The operation cannot be
performed with the disc or the
scene in play (also refer to the
instructions included with the
disc).
Adjust the brightness, tone, or
color depth on the monitor
connected to the unit.
Symptom Cause Remedy Page
No power
Magazine
cannot be
installed.
Play does not
begin.
When a
function button
is pressed,
only the “ ”
is displayed,
and the unit
does not
function.
Image color or
tone is poor.
For easier understanding, the following messages are displayed during operation. An error made during operation or installation can sometimes be mistaken for a
system malfunction. Check below before contacting your Authorized SANYO Service
Station.
Message displays Troubleshooting (1)
6
38
3
3
3
–
–
–
6
6
31
6
38~40
31
–
–
6
6
3
3
–
3
3
DV-S100/ZA(GB) 03.11.28 1:19 PM ページ43