Filter
Top Products
SIR-GTRC1 Streamer GTR User and Installation Guide
33
of a song or program may not be available in
memory. If this occurs, the playback will start
from where the audio began to be stored.
Pressing and holding the Rewind button for
one second rewinds playback in 10 second
intervals, which increase to 15 and then 30
second intervals the longer the Rewind button
remains pressed. Playback begins immediately
when the button is released. If the beginning
of the stored audio is reached while rewinding,
a beep will be heard and playback will
automatically begin.
Using Instant Replay
To begin using the Instant Replay feature of the
Receiver, press the Pause/Play button. This causes
the Receiver to enter the Instant Replay pause
mode, which mutes the audio from the Receiver.
A “Paused” message will be displayed for two
seconds to confirm that the Receiver has entered
the Instant Replay mode.
001 Ch. Name
Artist NameArtist Name
Song TitleSong Title
Paused
-00:00:03
To listen to the audio that was stored, press the
Play/Pause button again and the Receiver will
begin to play back the audio stored in the Instant
Replay memory from the point where you pressed
the Play/Pause button.
As you are listening to the playback of the stored
audio, you may either fast forward or rewind
through the stored audio by pressing the fast-
forward or rewind buttons, without having to press
the Play/Pause button first. Refer to the previous
sections describing the Rewind and Fast-Forward
buttons for specific instructions for their use.
Note: If the Receiver is tuned to another channel
while in the Instant Replay mode, the Instant
Replay mode is exited, all the audio stored in the
Instant Replay memory is erased, and the tuned
channel begins to play. Also note that tuning to
another channel may automatically occur if another
feature of the Receiver has been programmed to
do so.
When the Instant Replay mode is active, status
information is shown at the bottom of the Receiver’s
display screen.