5900335 © 2005 JCM-American Corporation
1-3
GENERAL INFORMATION Optipay™ CC Section 1
Configuration Tools
In order to react as quickly as possible to new false
coins in the workshop or on site, and enable indi-
vidual adjustments, the coin changer can be con-
nected to a:
•
JCM Programming Station consisting of:
–
WinEMP
©
configuration and diagnostics
software which includes the card reader and
chip card
–
Tester G-19.0641
•
JCM Palm Pilot
®
,
and applications PalmEMP
©
and PalmA66
©
for a Palm Pilot
®
handheld
Chapter 11 "Configuration" explains which of the
preceding configuration tools can be used to set the
different Coin Changer parameters.
Update Tools
The Coin Changer’s integrated Coin Validator is
equipped with microprocessor circuitry that con-
tains Flash Memory. This allows quick updates of
the Coin Validator’s operating software without
complications. In order to load new operating soft-
ware into the Coin Validator, one of the following
three alternatives is required:
•
a JCM PC Update Station consisting of:
–
WinFlash
©
software
–
Tester G-19.0641
–
Programming adapter G-19.0646
•
a JCM Flash Prommer G-55.0350 or
•
JCM Palm "PalmFlash
©
" application for a
Palm Pilot
®
handheld and a Flash Adapter
If it is desirable to test all functions and not
just the MDB functions, an additional G-
55.0348 RJ-45 PC plug adaptor is available
from JCM, allowing you to connect the Coin
Changer directly to the PC using the easily
accessible 8-pin modular RJ-45 jack
receptacle located on the top right side of
the device.
