5900335 © 2005 JCM-American Corporation
12-6
PALM PILOT® USAGE Optipay™ CC Section 12
4. Currency conversion settings
a). Select the
Service
tab on the main menu
screen (See Figure 12-18 a); then
b). Select
Convert currency
(See Figure 12-
18 b) to view the screen.
c). Set the required coin base and conversion
rate values. In addition, the appropriate
coin channel parameters must also be set.
e). Select
Send
when finished program-
ming (See Figure 12-18 c).
Changer Diagnostics
1. Select
Diagnostics
from the main menu
screen (See Figure 12-19 a-b).
a). The menu functions available
(See Figure 12-19 b) are as follows:
•
Software:
– Current software version
number
•
EMP:
– Changer self test
•
Sorting:
– Sorting gate test
•
Tube sensors:
– Self test
•
Payout module:
– Self test
•
Inhibit switches
– Current switch
positions graphic.
b). Select
Details
(See Figure 12-19 c) to
access the fault description
page
and review the fault status if any.
2. To view the changer statistical meters:
a). Click on the menu bar and then
b). Select from one of the three available
Meter lists (i.e.,
Error list
,
Statistic
counter 1
or
Statistic counter 2
[See Figure 12-20 a]).
c). The
“Error List”
reveals the
menu screen (See Figure 12-20 b) that dis-
plays an error
“Counter”
, error
“Code”
list
and 10 sensor type failure totals.
d). “
Statistic counter 1
” (See Figure 12-20 c)
displays the page 1 listing of the coins
accepted relative to the coin channel.
e). “
Statistic counter 2
” (See Figure 12-20 d)
displays the page 2 listing of the total
coins accepted, paid out, and rejected. It
also shows the total transactions for each
coin tube.
NOTE: Currency conversion can only be
set if multiple currencies are programmed
into the Coin Changer.
Figure 12-18 Conversion Setting Mode
a
b
c
Figure 12-19 Diagnostics Mode
a
c
b
Figure 12-20 Error List Mode
a
b
c
d
