Input and Output Label Panels
k Input and output label panels — These translucent panels can be removed and
replaced to insert labels behind the panels. To remove a panel, insert the Phillips-head
end of an Extron Tweeker or small Phillips-head screwdriver into the hole in one end
of the panel, and gently slide the tab at the edge of the panel out of the recess in the
switcher housing.
Input and output labels can be created easily with Extron button label generator
software, which ships with every Extron Matrix Switcher, or with any Brother P-Touch
labeler. Each input and output can be labeled with names, alphanumeric characters, or
even color bitmaps for easy and intuitive input and output selection (see figure 11 and
“Button Label Generator” in the Matrix Software section for details on using the label
software.
1 2 3 4 5 6 7 8
Rack DVD
(DVS 308)
COMPUTER INPUTS
Figure 11. Sample Label
Front Panel Operations
The following paragraphs detail the power-up process and then provide sample procedures
for the following actions:
Creating ties, sets of ties, and configurations
Changing a configuration
Viewing ties, sets of ties, and configurations
Muting and unmuting outputs
Saving a preset
Recalling a preset
Selecting the composite or S-video formats for inputs 11 through 14
Viewing and Adjusting the Input Audio Level
Viewing and Adjusting the Output Volume
Setting the front panel locks
Performing front panel resets
Reading and setting the RS-232 Primary port settings
Throughout this section, the following symbols are used:
= lit
= unlit
= not applicable in the example in which it appears
= blinking.
MPX 866 A Media Presentation Matrix Switcher • Operation 22
