Section 9: Factory Resets
SATO M10e Service Manual PN: 9001113A Page 9-4
11 Press the ENTER key to test print. Press the ENTER key again to stop printing.
12 Verify that the counters on the test print have reset to 0.0 km.
13 Power Off the printer and confirm that all switches are in the Off or down position.
CLEAR EEPROM
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys when the printer beeps.
6 Place the DSW2-4 in the Off position.
7 Use the CURSOR keys to advance to the next display.
8 Press the ENTER key to select the All Clear Mode option and advance to the next display.
9 Press the ENTER key to select the Clear Counter option and advance to the next display.
10 Use the CURSOR keys to step the cursor to the YES option.
11 Press the ENTER key to select and clear the EEPROM.
WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON
THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING
PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT
PRINT HEAD DAMAGE.
CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
LCD DISPLAY: MAINTENANCE MODE
DIPSW2-4 ON->OFF
LCD DISPLAY: FACTORY MODE
LCD DISPLAY: ALL CLEAR MODE
LCD DISPLAY: ALL CLEAR COUNTER
EEPROM
LCD DISPLAY: COUNTER ALL CLEAR
YES NO
