Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-18
9 Route wiring harness as was removed and connect to the ribbon drive board.
10 Secure wiring harnesses to the printer frame with cable bracket (5) and screw (4).
11 Reconfigure ribbon rewind belt (8) onto the motor spindle.
12 Orient cover (2) onto ribbon frame (3) and secure using two screws (1).
13 Install ribbon stock and test cycle the printer to ensure a proper function.
14 Install the left, front, and top housing covers.
Figure 7-14, Ribbon Motor Replacement
NOTE: If unable to connect the motor wiring harness to the ribbon drive
board with the main circuit board installed, remove the main circuit board in
accordance with the Main Circuit Board Replacement procedures found in
this section.
NOTE: Figures 10-1 and 10-3 of the Diagrams & Schematics section
provides guidance on housing cover and ribbon installation.
A
A
7
2
1
4
5
6
3
8
