Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-22
3 Remove media from printer if applicable.
4 Remove the optional cutter assembly or tear-off cutter as applicable.
5 Remove two screws (1, Figure 7-17) on each end of stay bar (2). Lift away stay bar (2).
Figure 7-17, Eye-Mark/Label-Out Sensor Replacement
6 Remove thumbscrew (3) securing label-gap sensor and left guide plate (4) to rack plate (5).
7 Move left guide plate (4) aside to provide a clear view of rack plate (5) and glassed window
(6).
8 Insert hand under ramp to touch the head of eye-mark sensor mounting screw (7).
9 Disconnect sensor wiring harness (A) from sensor (8).
10 Using a short driver, remove screw (7) securing sensor (8). Lift away defective sensor (8).
11 Secure replacement sensor (8) to printer using screw (7).
NOTE: If the optional cutter assembly is installed, instructions for its removal
may be found in the Replacement section of this manual. The tear-off cutter
may be removed by removing the two screws on the left end and one screw
on the right end of the cutter.
NOTE: The eye-mark sensor board may be seen just under the glassed
window and its mounting screw on the left end of the board. Take note of the
orientation of the sensor board.
3
4
6
1
2
1
7
5
8
A
A
