Filter
Top Products
Installation
i
Notice!
Refer to the appropriate Installation Supplement included with your product for the specifics
of your particular installation.
Installation Check List
Check each receiver card to see that it is correctly positioned in the card guides at the
top and bottom of the enclosure. Also confirm that connections did not loosen during
shipment (D6600 only).
Check each receiver card to see that it is correctly positioned in the card guides at the
top and bottom of the enclosure. Also confirm that connections did not loosen during
shipment (D6600 only).
Ensure that the earth ground is connected and grounded through the AC inlet.
If you are installing additional line cards, install the terminator cards now (D6600 only).
After installing additional line terminator cards, install the line cards (refer to Card
Installation, page 20).
Install the line terminator card(s) from your spares package(s). If there is a malfunction,
you can quickly switch over to the replacement card (refer to Card Installation, page 20).
i
Notice!
You can install spare line terminator cards. Do not install spare line cards.
Connect four or six conductor telephone cord(s) to the RJ11C jack(s) of the desired
telephone line(s). Plug the other end of the modular telephone cord(s) into the telephone jack
on the appropriate line terminator card(s).
Connect the supplied AC transformer wiring leads to the AC terminals on the rear of the
D6100IPv6.
Plug the AC cord (D6600 only) into a correctly wired 120 VAC, 60 Hz or 220 VAC, 50 Hz
outlet (standard AC outlet).
i
Notice!
Maintain a 6.5 mm (0.25 in) gap, or greater, between power limited and non-power limited
circuit wiring.
Plug the AC transformer into the correctly wired wall receptacle that matches the voltage
of the transformer.
8
8.1
Conettix Communications Receiver/
Gateway
Installation | en 25
Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704