Filter
Top Products
Config
Section
Config
Sub-
section
Config
Parameter
Default
Value
Valid Values Description
interface eth0 dhcp enable enable, disable Determines if IPv4 DHCP is used. If this is set
to disabled, then a Static IPv4 Address needs
to be specified in the IP Address
Configuration Parameter.
interface eth0 ip address <None
>
Accepts an
IPv4 address
and mask as
either:
1 IP address
only
(192.168.1.1)
gets a default
mask,
2 CIDR
(192.168.1.1/2
4),
3 Explicit mask
(192.168.1.1
255.255.255.0
)
If IPv4 DHCP is disabled, then an IPv4
Address must be entered here.
Conettix Communications Receiver/
Gateway
Network Communications | en 61
Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704