Filter
Top Products
9. Type open <IP ADDRESS> 9999 and press Enter (for example, open 172.17.10.70 9999).
10. Press Enter. The Setup Mode information appears.
Configuration Using Telnet
1. Type 0 (zero) and press Enter to set up the basic server configuration.
If the D6100i was previously programmed with an IP address, the address appears in
parentheses.
2. Type the IP address (for example, 190.200.128.219) and press Enter.
3. If the Gateway address is required, type y, press Enter] and then type the address and
press Enter. If the Gateway address is not required or if you use DHCP, type n and press
Enter.
The following prompt appears.
i
Notice!
The Gateway IP is required only if you are connecting to a WAN. In a LAN, the Gateway IP is
usually not needed unless the Gateway IP of the PC is different from the Gateway to which
the D6100i is connected.
4. If Network needs to be changed from the default, enter the number of bits that
correspond to the netmask your network uses and press Enter. Contact your network
administrator if you need more information about the netmask.
Host Bits Netmask Host Bits Netmask
1 255.255.255.254 17 255.254.0.0
2 255.255.255.252 18 255.252.0.0
3 255.255.255.248 18 255.248.0.0
4 255.255.255.240 20 255.240.0.0
5 255.255.255.224 21 255.224.0.0
6 255.255.255.192 22 255.192.0.0
7 255.255.255.128 23 255.128.0.0
8 255.255.255.0 24 255.0.0.0
9 255.255.254.0 25 254.0.0.0
10 255.255.252.0 26 252.0.0.0
11 255.255.248.0 27 248.0.0.0
12.5.5
Conettix Communications Receiver/
Gateway
Network Communications | en 67
Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704