Filter
Top Products
The host computer is any computer or workstation that is connected to the network you will
use to manage/administer the D6600/D6100IPv6 and other devices. Any existing laptop or
desktop computer on the network can be used. However, for security reasons, it is best that
the computer not be used as a regular workstation. This computer is also the computer on
which you install the D6200 Software. The D6200 Software is used to program and administer
the D6600/D6100IPv6 and other devices. Separate sections are provided for setting up the
host computer in Windows 2000, XP, Vista, Windows 7, and Windows 8.
If the host computer is running Windows XP, 2000, Vista, or Windows 7 and is new to the
network, you must perform the following steps:
i
Notice!
Although the screen captures in this procedure are specific to Windows 2000, they are similar
for Windows XP, Vista, and Windows 7.
Setting up the IP address:
1. Select Start → Settings → Control Panel.
2. When the control panel is open, find and double-click the Network and Dial-up
Connections icon to launch the Network and Dial-up Connections control panel.
3. Double-click Local Area connection.
4. Right-click the icon and select Properties.
5. Scroll in the Components checked are used by this connection: list and select Internet
Protocol (TCP/IP).
Figure 12.3: Local Area Connection Properties
6. Select the protocol icon for TCP/IP and click Properties.
7. When the dialog box appears, select Use the following IP address: Enter an IP address
and subnet mask for the network you are setting up.
Conettix Communications Receiver/
Gateway
Network Communications | en 47
Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704