Filter
Top Products
3 Operating the Equipment Locally
Chapter 3
Contents
3.1 Powering the Equipment ......................................................................3-5
3.1.1 Switching On ........................................................................................3-5
3.1.2 Power up Operating Modes.................................................................. 3-5
3.2 Front Panel Controls and Pushbuttons................................................. 3-6
3.3 Front Panel Operating Modes ..............................................................3-6
3.3.1 General.................................................................................................3-6
3.3.2 Navigate Mode .....................................................................................3-6
3.3.3 Edit Mode .............................................................................................3-7
3.4 Using the Local Controls ......................................................................3-7
3.4.1 LCD Menu Descriptions........................................................................ 3-7
3.4.2 Selecting a Menu Option ......................................................................3-8
3.4.3 Entering a Menu Value .........................................................................3-8
3.5 Setting Up Preset Services (Menu 1) ................................................... 3-9
3.5.1 Using Preset Services ..........................................................................3-9
3.5.2 Setting Up a Preset Service .................................................................3-9
3.6 Setting Up the Input (Menu 2) ............................................................3-10
3.6.1 DVB-S2 Satellite Receiver (TT1290/HWO/DVBS2 and
TT1290/HWO/DVBS2/IF/CONST)......................................................3-10
3.6.1.1 DVB-S2 Input Option Card TT1290/HWO/DVBS2/IF/CONST............3-11
3.6.2 Telco Receiver – RX1290/HWO/G703 ............................................... 3-11
3.6.3 10/100BaseT Input – RX1290/HWO/IP .............................................. 3-12
3.6.4 100/1000BaseT Dual IP Input – RX1290/HWO/GIGE........................3-13
3.7 Service Configuration (Menu 3).......................................................... 3-14
3.7.1 Selecting and Setting Up a Service ....................................................3-14
3.7.2 Selecting the Video Component .........................................................3-14
3.7.3 Setting Down Conversion Mode ......................................................... 3-15
3.7.4 Setting SD Monitor Aspect Ratio ........................................................3-15
3.7.5 Setting Video Delay ............................................................................3-16
3.7.6 Setting Video Output mode ................................................................3-16
3.7.7 Setting Low Delay Mode – RX1290/SWO/LDELAY ...........................3-16
3.7.8 Selecting the Audio Component .........................................................3-17
3.7.8.1 Introduction.........................................................................................3-17
3.7.8.2 Selecting the Audio Manually .............................................................3-17
3.7.9 Setting Up Asynchronous Data (RS-232)........................................... 3-18
3.7.10 Setting Up High Speed Data Over Ethernet –
RX1290/SWO/HSETHER................................................................... 3-18
3.7.11 Setting Up Teletext .............................................................................3-19
EN/LZT 790 0003/2 R1A
3-1