Operating the Equipment Locally
Step Action Result
6
Scroll to Menu 6.4 and edit the
AUDIO 2 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Edits the Audio 2 alarms menu.
7
Scroll to Menu 6.5 and edit the
AUDIO 3 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Edits the Audio 3 alarms menu.
8
Scroll to Menu 6.6 and edit the
AUDIO 4 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Edits the Audio 4 alarms menu.
9
Scroll to Menu 6.7 and edit the
MER menu (NO ALARM, SET
ALARM ONLY). Press Save.
Edits the MER Error Rate (00.0 to 69.9) and
status menu.
10
Scroll to Menu 6.8 and edit the
BER menu (NO ALARM, SET
ALARM ONLY). Press Save.
Edits the BER Error Rate (00.0 to 69.9) and
status menu.
11
Scroll to Menu 6.9 and edit the
EBNO menu (NO ALARM, SET
ALARM ONLY). Press Save.
Edits the EBNO
12
Scroll to Menu 6.10 and edit the
TEMPERATURE menu (NO
ALARM, SET ALARM ONLY).
Press Save.
Edits the Temperature menu.
3.11 Setting Up System Parameters (Menu 7)
This menu gives access to the Set-up Menu to set-up and edit System Parameters
as well as the Multi-Format Receiver Details menu (see Table 3.42).
Table 3.41 Setting Up a System
Step Action Result
1 Go to Menu 7. Accesses the System menu.
2
Scroll to Menu 7.1 and edit the
Operating Mode (FRONT PANEL,
SERIAL REMOTE, NCP or NETWORK
(SNMP). Press Save.
Edits the Operating Mode menu.
3
Scroll to Menu 7.1.1 and edit the LCD
Contrast (LOW, MEDIUM or HIGH).
Press Save.
Edits the LCD Contrast.
4
Scroll to Menu 7.1.2 and edit the
SERIAL REMOTE PROTOCOL mode
(RS232 ALTEIA or RS485 ALTEIA).
Select the interface needed for serial
remote control.
5
Scroll to Menu 7.1.3 and edit the IP
Address. Press Save.
Edits the IP Address.
EN/LZT 790 0003/2 R1A
3-27