Ericsson RX1290 Car Satellite TV System User Manual


 
Operating the Equipment Locally
3.6.1.1 DVB-S2 Input Option Card TT1290/HWO/DVBS2/IF/CONST
The DVB-S2 demod option TT1290/HWO/DVBS2/IF/CONST offers three
L-band inputs plus an IF input. If this input option card is fitted in the receiver then
note that Menu 2.3.5 sets the IF input frequency. LNB Frequency, Satellite
Frequency and LNB Power parameters are not applicable for this input.
The DVB-S2 demod option TT1290/HWO/DVBS2/IF/CONST also offers a
constellation output in DVB-S2 mode. This output can be enabled for each L-
band/IF input from the menu 2.3.X.6. Enabling this mode disables the demodulator
transport stream rendering the receiver unable to decode a service.
3.6.2 Telco Receiver – RX1290/HWO/G703
Table 3.7 steps through the set-up procedure of the Telco Receiver using
Menu 2 Input, and the TTV G.703 input.
Table 3.7 Setting Up the TTV G.703 Interface
Step Action Result
1
Connect the cable to the TTV
G.703 input.
2
Power up the unit and navigate
to Menu 2 Input.
Accesses the Input menu.
3
Press the Right pushbutton to
access Menu 2.3.
Selects the G.703 menu.
4
Navigate to INTERLEAVER
(Menu 2.3.3), then press Edit.
Select Enable or Disable, then
press Save.
Sets the required interleaving.
5
Navigate to SIGNAL LEVEL
(Menu 2.3.4), then press Edit.
Select Normal or Low, then
press Save.
Sets the unit sensitivity to the input signal level.
6
Navigate to REED-SOLOMON
(Menu 2.3.2), then press Edit.
Select ENABLE, then press
Save.
Enables FEC functionality.
7
Return to Input Menu 2, it should
display the current status. If
status is NOT LOCKED, verify
that the cable is properly
connected and that all values
have been entered correctly.
EN/LZT 790 0003/2 R1A
3-11