Filter
Top Products
61
DRC: set the DRC (dynamic range control) for better playback for low volume playback: On (use bass to play
the more dynamical audio), Off (normal playback).
Center delay: the time difference between center and front speakers. The time delay makes audio signal more
accurate. Select the time delay: 0 ms (same time output with front speakers), 1 ms (1 millisecond delay), ..., 5 ms.
Rear delay: the time difference between rear and front speakers. The time delay makes surround effect more
better. Select the time delay: 0 ms (same time output with front speakers), 3 ms (3 milliseconds delay), ..., 15 ms.
Note: REAR CTRL may be adjusted only when center speaker is set as small or large.
Down sampling: depending on the mode the signal output will be normal or 48 kHz. Select the mode: On (all
the signals will be 48 kHz), Off (all the signals will be normal).
SPK configuration
1. Enter the SPK CONFIG menu.
2. Use the buttons on the panel or 8/ buttons on the RC or touch
the desired item on the screen to select the settings: Multi-CH, Stereo,
Sub W, Center.
3. Press the buttons on the panel or 9/: buttons on the RC or touch
the desired button on the screen to enter the list of values.
4. Press the buttons on the panel or 8/ buttons on the RC or touch
the desired button on the screen to select the desired value.
5. Press PLAY/PAUSE button to confirm.
Multi-Ch: set up the front speakers: Large (suitable for speakers with good bass output), Small (for speakers
with bad bass output).
Stereo: set up the rear speakers: Large (suitable for speakers with good bass output), Small (for speakers with
bad bass output), None (rear speaker is not employed).