Filter
Top Products
F940GOT Handy Series Installation 3
3-10
3.4.2 Using the F943GOT Handy
Installing a connector on the panel of a control box or cabinet
Connect a Q Series PLC using a relay cable as shown below.
a) External cable (with 37-pin D-Sub, male connector)
F9GT-RHCAB-3M (3m /9' 10")
b) Relay cable for connection to Q series PLC
F9GT-RHCAB5-150 (1.5m /4' 11") for Q series PLC
Note:
When connecting to a port or unit other than the programming port of a Q series PLC, make
a cable corresponding to the configuration of the communications port in question. For
allocation of Handy GOT communication signals, refer to section 3.2.
POWER GRIP SW
a )
b )
P L C
F 9 4 3 G O T H a n d y
C o n t o r o l b o x o r c a b i n e t