Filter
Top Products
System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 56.
2 Touch AUX Input on the system menu
to tur n AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 56.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the RGB Input
You can switch the setting of RGB input.
1 Display the system menu.
Refer to Introduction of menu operations on
page 56.
2 Touch RGB Input on the system menu
to tur n iPhone or NAVI.
Note
If you use Advanced App Mode, set to iPhone.
Setting the App sound mixing
You cannot turn on or off Mixing when this
unit is playing a song of iPod.
The sound of application during Advanced
App Mode can be adjusted.
Enable this setting when you want to mix the
App sound with the sound from a built-in
source (such as the radio). The volume of the
App sound can be selected from 3 levels.
1 Display the system menu.
Refer to Introduction of menu operations on
page 56.
2 Touch App sound mixing on the System
menu to select desired setting.
OFF (off)—Low (low)—Mid (mid)—High
(high)
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Full) or subwoofer
(Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (Full).
1 Turn the unit off.
Refer to Basic operations on page 14.
2 Press HOME to switch to the HOME dis-
play.
3 Touch System key.
System menu is displayed.
4 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select Subwoofer (subwoofer).
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 58).
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the Tag forwarding
The song information (tag) can be saved from
the broadcasting station of HD Radio to your
iPod.
En
64
Section
15
Menu operations