Filter
Top Products
Important
! This unit cannot be installed in a vehicle with-
out ACC (accessory) position on the ignition
switch.
O
N
S
T
A
R
T
O
F
F
ACC position No ACCposition
! Use this unit with a 12-volt battery and nega-
tive grounding only. Failure to do so may result
in a fire or malfunction.
! To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
— Disconnect the negativeterminal of the
battery before installation.
— Securethe wiring with cable clamps or ad-
hesive tape. Wrap adhesive tape around
wiring that comes into contact with metal
parts to protect the wiring.
— Placeall cablesaway from moving parts,
such as the shift lever and seat rails.
— Placeall cablesaway from hot places,
such as near the heater outlet.
— Do not connectthe yellowcable to the bat-
tery bypassing it through the hole to the
engine compartment.
— Coverany disconnected cable connectors
with insulating tape.
— Do not shorten any cables.
— Nevercut the insulation of the power cable
of this unit in order to share the power
with other devices. The current capacity of
the cable is limited.
— Usea fuse of the rating prescribed.
— Never wire the negative speaker cable di-
rectly to ground.
— Neverband together negative cables of
multiple speakers.
! When this unit is on, control signals are sent
through the blue/white cable. Connect this
cable to the system remote control of an exter-
nal power amp or the vehicle’s auto-antenna
relay control terminal (max. 300mA 12VDC).
If the vehicle is equipped with a glass anten-
na, connect it to the antenna booster power
supply terminal.
! Never connect the blue/white cable to the
power terminal of an external power amp.
Also, never connect it to the power terminal of
the auto antenna. Doing so may result in bat-
tery drainor a malfunction.
! IP-BUS connectors are color-coded. Be sure
to connect connectors of the same color.
En
79
Section
17
Installation
Installation