Filter
Top Products
23
HT-DV40H
HT-DV50H
Preparation for Use
Changing the set up menu
Notes:
The setting are stored even if the unit is set to stand-by mode.
The backup function protects the stored setting for a few hours
should there be a power failure or AC power lead disconnection.
System set up can be performed during playback mode.
1 2 3
4 5 6
7 8 9
+100
1 Turn on the TV.
2 Set the TV to the correct input, eg. “AV1”, “VIDEO”, etc.
3 Turn on the unit by pressing the
ON/STAND-BY button.
The SHARP startup screen appears.
Note:
Startup screen will be displayed when
both S-Video cable and SCART cable
are connected to the TV. If only the S-
Video cable is connected, the screen
may be blank. To set up S-Video mode,
use video out cable or SCART cable.
4 Press the SHIFT and SET UP buttons.
5 Press the or button to select a menu.
See the list on pages 24 - 29 for set up menu.
6 Press the , , or button to change the setting and
press the ENTER button.
7 After setting is completed, select
“EXIT SET UP”, then press the ENTER
button to return to the main page.