Filter
Top Products
You may not be able to operate your HDD AUDIO PLAYER with HDD Audio Remote if
your router is set to low power consumption mode. In this case, disable low power
consumption mode of your router. For details, refer to the operating manual of your
router.
The HDD AUDIO PLAYER responds slowly to
operations.
The HDD AUDIO PLAYER responds slowly to operations performed on the HDD AUDIO
PLAYER or by HDD Audio Remote while music files are being transferred or the HDD
AUDIO PLAYER is analyzing and registering music files. This is not a malfunction.
No sound is output or sound is interrupted.
Check that the speakers are connected to the HDD AUDIO PLAYER correctly.
Press MUTING on the remote control to cancel the muting function.
Check that headphones are not connected. If headphones are connected, sound is not
output from the speakers.
Check that the correct input jack(s) are being used.
Check that the cord(s) are connected to the correct input jack(s) on the selected
equipment.
Check that both the HDD AUDIO PLAYER and the connected equipment are turned on.
Sound may be interrupted when the sampling frequency or audio format is changed.
Only 2ch tracks are supported in any of the playable file formats. Tracks other than 2ch
tracks cannot be played.
DRM (Digital Rights Management)-protected music files cannot be played.
Confirm the audio file formats that can be played.
If the HDD AUDIO PLAYER is being used with a television, speakers, video deck or tape
deck and is placed too close to that equipment, noise may result.
Audio formats other than LPCM 2ch cannot be played through the OPTICAL IN or
COAXIAL IN jacks.
The HDD AUDIO PLAYER does not output a signal through the D/A DIRECT・LINE OUT
jacks when [LINE IN 1] or [LINE IN 2] is selected in the [External Input] menu.
If you are using an external hard disk drive, skipping may occur in the playback sound
depending on the hard disk performance.