Filter
Top Products
6. When the network connection is completed, confirm the message about the wired LAN
and Internet access on the screen and then select [OK].
[27] Network connections (wired LAN)
Connecting the HDD AUDIO PLAYER to a network
manually
You can enter the IP address and other network information manually to connect the HDD
AUDIO PLAYER to a wired network. Make sure that you have information such as the IP
address, subnet mask, default gateway and primary/secondary DNS in advance.
1. Select [Settings] - [Network Settings] - [Internet Settings] from the Home screen.
2. Select [Wired Setup].
3. Select [Custom] on the IP address settings confirmation screen.
4. Select [Specify IP Address].
An input screen for information such as IP address, subnet mask and default gateway
appears.
5. When the IP address is surrounded by a white box, push the jog dial in.
An input segment appears for the IP address.
6. Enter the IP address.
Turn the jog dial to select a value and push it in to enter the selection. When you push
the jog dial in, the input segment moves to the next number. When you push the jog
dial in at the furthest right segment, the IP address is confirmed and the whole IP
address is surrounded by the white box again.
7. If you also want to enter a subnet mask, default gateway or primary/secondary DNS,
select the item you want to enter.
Repeat the same operations as step 6.
When the input is completed, a screen showing the network settings information
appears.
8. Select [Next].
A confirmation message for the LAN cable connection appears.
9. Select [Save & Connect].