Filter
Top Products
Messages for protecting the HDD AUDIO PLAYER
If the HDD AUDIO PLAYER detects an abnormality inside the unit, one of the following
messages appears for about 5 seconds and then the HDD AUDIO PLAYER automatically
enters the standby mode.
Note
The HDD AUDIO PLAYER enters the normal standby mode, even if the Network Standby
mode is set to [On].
The next time you turn the power on, the volume will be at the minimum.
AMP PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off,
remove any objects covering the ventilation holes and then turn the power on again.
HDD PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off and
remove any objects covering the HDD AUDIO PLAYER. Wait until the HDD AUDIO PLAYER
cools down sufficiently and then turn the power on again.
USB PROTECTOR
An abnormal current is being output to the EXT port on the rear of the HDD AUDIO
PLAYER. Turn the power off, confirm the connection and then turn the power on again.
CPU PROTECTOR
The internal temperature of the HDD AUDIO PLAYER is too high. Turn the power off and
remove any objects covering the HDD AUDIO PLAYER. Wait until the HDD AUDIO PLAYER
cools down and then turn the power on again.
[90] Dealing with problems/Inquiries
Other messages
If the HDD AUDIO PLAYER detects an abnormality in the internal or external hard disk
drives, one of the following messages appears.
Cannot complete formatting. Some errors were found in the HDD.
A malfunction may have occurred in the external hard disk drive. Use another external hard
disk drive.
Cannot complete rescanning. Some errors were found in the HDD.
The following may be reasons for the malfunction.