Filter
Top Products
turned off. This allows you to start up or operate the HDD AUDIO PLAYER from the HAP
Music Transfer or HDD Audio Remote application. This mode also reduces the startup time
of the HDD AUDIO PLAYER.
Off:
The power consumption is lower than when the Network Standby function is set to [On], but
the startup time when the HDD AUDIO PLAYER is turned on is longer (factory default
setting).
Setting the Auto Standby function (Auto Standby)
If you set the Auto Standby function to [On], if you do not operate the HDD AUDIO PLAYER
and do not play tracks for approximately 20 minutes, the unit is automatically turned off and
enters standby mode to reduce the power consumption.
1. Select [Settings] - [System Settings].
2. Select [Auto Standby].
3. Select [On] (factory default setting).
Note
The Auto Standby function does not work during the following processes:
Updating the software
Formatting the hard disk drive
Rescanning a hard disk drive
Resetting the product (performing the Factory Reset function)
When the Sleep timer is working
Transferring music files from a computer
Playing music via external input
Hint
When the remaining time until the HDD AUDIO PLAYER enters the standby mode is less
than 60 seconds, the remaining time is shown on the screen.
When the HDD AUDIO PLAYER is in standby mode, you can start the HDD AUDIO
PLAYER by pressing the button or button on the remote control or the HDD
AUDIO PLAYER, or by operating HDD Audio Remote (only when the HDD AUDIO
PLAYER is in Network Standby mode).