Filter
Top Products
The remote control does not work.
Point the remote control at the remote sensor on the HDD AUDIO PLAYER.
Remove any obstructions in between the remote control and the HDD AUDIO PLAYER.
Replace all the batteries in the remote control with new ones if they are low.
You cannot operate the connected Sony amplifier or an
amplifier from another manufacturer.
If you operate the connected amplifier using the remote control supplied with the HDD
AUDIO PLAYER, operation of the amplifier may become inconsistent (operating at times
but not operating at other times) due to interference of the remote control signal,
especially if you continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the
remote sensor (receiver) of the connected amplifier, interference may occur with the
signal input from the IR input jack of the amplifier or the signal output from the installed IR
blaster. This causes the amplifier to fail to receive the correct signal, resulting in
inconsistent response from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared
signal of the remote control of the HDD AUDIO PLAYER.
It is recommended that you use HDD Audio Remote, to avoid interference problems.
Even if you configure the remote control supplied with the HDD AUDIO PLAYER so that it
can operate equipment manufactured by other companies, the remote control may not
work correctly depending on the manufacturer or manufacture year of the equipment.
Cannot transfer music files via HAP Music Transfer.
Make sure that the HDD AUDIO PLAYER is turned on.
Check the network connection.
Make sure that the computer where the music files are stored is connected to the same
network as the HDD AUDIO PLAYER.
If the HDD AUDIO PLAYER is in normal standby mode, music files cannot be transferred
via HAP Music Transfer. Set the HDD AUDIO PLAYER to the Network Standby mode.
You may not be able to transfer files from HAP Music Transfer if your router is set to low