Filter
Top Products
sensor of the HDD AUDIO PLAYER and press the button of the function being learned,
such as the power button.
The HDD AUDIO PLAYER learns this function of the remote control of your amplifier.
When the learning is completed, the Learning Complete screen appears.
8. If you want to test the connection to confirm that the learning has been completed,
select [Yes].
9. Confirm the instructions on the screen and then select [Start].
The connection test starts.
10. When you have confirmed that no problems have been found in the test, select [Finish
Test].
The screen returns to the list of the settings. If you want to configure another function,
select the function and repeat the procedures from steps 6 to 10.
11. When configuration of the settings is completed, select [Exit].
Note
If the HDD AUDIO PLAYER is turned off or in standby mode, you cannot adjust the
volume or mute the amplifier using the remote control supplied with the HDD AUDIO
PLAYER.
The HOME and BACK buttons will not work while [Learning…] is displayed in step 7.
This function is not necessarily compatible with all amplifiers from other manufacturers.
Hint
You can also configure settings so that they are not controlled by the remote control, such
as when you want to turn the power of the HDD AUDIO PLAYER off but do not want to
turn the amplifier off.
If you want to change the status of a function that has been learned and is to be used ([In
use] is displayed), select [Not in use] in step 6.
If you want the HDD AUDIO PLAYER to relearn a function that has been learned and is to
be used ([In use] is displayed), select [Relearn] in step 6.
If you operate the connected amplifier using the remote control supplied with the HDD
AUDIO PLAYER, operation of the amplifier may become inconsistent (operating at times
but not operating at other times) due to interference of the remote control signal,
especially if you continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the
remote sensor (receiver) of the connected amplifier, interference may occur with the
signal input from the IR input jack of the amplifier or the signal output from the installed IR
blaster. This causes the amplifier to fail to receive the correct signal, resulting in
inconsistent response from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared
signal of the remote control of the HDD AUDIO PLAYER.