Filter
Top Products
blaster (supplied) to the IR REMOTE OUT jack of the HDD AUDIO PLAYER, and
place the other side of the IR blaster (the side to radiate infrared) close to the remote
sensor of the amplifier.
7. Select [Next].
8. Select the remote code of the connected amplifier.
If you are using a Sony 2ch amplifier, select [2ch Amplifier].
If you are using a Sony AV amplifier, select [AV Receiver 1] or [AV Receiver 2]
according to the remote code configured for the AV amplifier.
If you do not know which remote code should be set for your AV amplifier, select [AV
Receiver 2] at first and confirm whether IR signal is output. If the AV amplifier does
not work, select [AV Receiver 1]. Refer to the operating manual of the AV amplifier
for details.
A list of settings appears.
9. Select a setting you want to configure.
10. Select [In use].
Select [Not in use] for items you do not want to set.
11. Select [Next].
12. Select [Test].
Select [Exit] if you do not want to test.
13. Confirm the instructions on the screen and then select [Start].
The connection test starts.
14. When you have confirmed that no problems have been found in the test, select [Exit].
Note
If the HDD AUDIO PLAYER is turned off or in standby mode, you cannot adjust the
volume or mute the amplifier using the remote control supplied with the HDD AUDIO
PLAYER.
Hint
You can also configure settings so that they are not controlled by the remote control, such
as when you want to turn the power of the HDD AUDIO PLAYER off but do not want to
turn the amplifier off.
If you operate the connected amplifier using the remote control supplied with the HDD
AUDIO PLAYER, operation of the amplifier may become inconsistent (operating at times
but not operating at other times) due to interference of the remote control signal,
especially if you continuously control the volume.
For example, if the infrared signal from the supplied remote control directly enters the