Filter
Top Products
remote sensor (receiver) of the connected amplifier, interference may occur with the
signal input from the IR input jack of the amplifier or the signal output from the installed IR
blaster. This causes the amplifier to fail to receive the correct signal, resulting in
inconsistent response from the amplifier.
In this case, place the amplifier in a location where it will not be affected by the infrared
signal of the remote control of the HDD AUDIO PLAYER.
It is recommended that you use HDD Audio Remote, to avoid interference problems.
Operating an amplifier manufactured by another
company using the supplied remote control or a
dedicated application
If you register the remote control supplied with a connected amplifier manufactured by
another company to the HDD AUDIO PLAYER, you can perform operations such as turning
on/off the amplifier, adjusting the volume and muting the sound through the remote control
supplied with the HDD AUDIO PLAYER or the HDD Audio Remote application.
1. Select [Settings] - [Amp Control Settings] in the Home screen.
2. Confirm the description about the AMP Control Settings, and then select [Next].
The current settings are displayed.
Not learned: a function that has not been learned yet
In use: a function that has been learned and is to be used
Not in use: a function that has been learned but is not to be used
3. Select [Next].
A screen to select the manufacturer of the connected amplifier appears.
4. Select [Other].
5. Follow the instructions on the screen to connect the plug of the IR blaster (supplied) to
the IR REMOTE OUT jack of the HDD AUDIO PLAYER and place the other side of the
IR blaster (the side to radiate infrared) close to the remote sensor of the amplifier, and
then select [Next].
6. Select a function you want the HDD AUDIO PLAYER to learn from functions indicated
as [Not learned].
The [Learning…] status appears.
7. While [Learning…] is displayed, aim the remote control of your amplifier at the remote