Sony KDL-55W829B/50W829B KDL-55W828B/50W828B Car Satellite TV System User Manual


 
2. When using the Active 3D Glasses for the first time, hold the glasses within 50 cm (1.6 ft.) of
the TV, turn on the TV, then press and hold the (Power) button/indicator on the glasses for
2 seconds.
The Active 3D Glasses turn on and registration starts (The (Power) button/indicator blinks
green and yellow). When registration is finished, a message appears in the bottom right
corner of the TV screen for 5 seconds, and the indicator will light up in green for 3 seconds.
This process is only required one time.
If registration fails, the Active 3D Glasses will turn off automatically. In this case, repeat the
above procedure.
3. Display the content to watch in 3D on the TV screen.
4. Put the Active 3D Glasses on.
While watching a 3D image, the
(Power) indicator blinks green every 2 seconds.
If no 3D effect is achieved, perform the following steps.
5. Press the 3D button to display the [3D Display] screen.
(When using the Touchpad Remote Control, press the Control Bar (
), slide the touchpad
to highlight the 3D button, then press the touchpad to select.)
6. Press the 3D button repeatedly to select the [3D Display] mode to suit the displayed content.
(When using the Touchpad Remote Control, press the Control Bar (
), slide the touchpad
to highlight the 3D button, press the touchpad, slide the touchpad to highlight the desired [3D
Display] mode, then press the touchpad.)
[3D (Side-by-Side)]: Displays side-by-side pictures in 3D.
[3D (Over-Under)]: Displays over-under pictures in 3D.
[3D (Simulated 3D)]: Displays regular 2D pictures in simulated 3D.
[2D (Left-Only)]: When the same picture is side-by-side, the left side picture is shown
expanded, in 2D.
[2D (Top-Only)]: When the same picture is over-under, the upper picture is shown expanded,
in 2D.
Depending on the input signal or format, [3D (Side-by-Side)]/[3D (Over-Under)]/[2D (Left-
Only)]/[2D (Top-Only)] may not be selectable.
To turn off the Active 3D Glasses
Press down on the (power) button of the Active 3D Glasses for 2 seconds. If no signal from the
TV is detected for more than 1 minute, the Active 3D Glasses will turn off automatically. To turn
them on again, press the
(power) button.
To use the Active 3D Glasses with another TV
It is required to re-register the Active 3D Glasses. Turn off the Active 3D Glasses, then perform
step 2.
To deactivate the 3D effect
Press the 3D button repeatedly to select [Off] in [3D Display].
(When using the Touchpad Remote Control, press the Control Bar (
), slide the touchpad to
highlight the 3D button, press the touchpad, slide the touchpad to highlight [Off] in [3D Display],
57