Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Order Information
9176/D173 D
ISK SUBSYSTEM - SITE PREPARATION GUIDE 11
S
IXTH EDITION
Cabinet Description
StorageTek provides a 19 inch rackmount cabinet for the Disk Storage environment. The
cabinet conform to the EIA-310-D standard using the modular unit U to indicate panel
height. The unit U equals 44.45mm or 1.75 inches. The CBNT M03 is a fixed 39U size. It
allow you to easily add more storage in the future. The Siebel configurator will not allow
you to go beyond 39U of space without ordering an additional cabinet. Each 445 mm wide
9176 Disk Controller uses 4U of internal vertical space and each 449 mm wide 9170 Disk
Array or D173 Disk Controller Array uses 3U of internal vertical space.
NOTE StorageTek’s earlier M01 and M02 cabinets are both being discontinued. Most
of the same information applies, however, they will soon be replaced with new
more cost-efficient cabinets once current stock has been depleted.
CBNT M03 Power Source
Each cabinet has redundant power distribution, and comes with two different types of AC
power connections.
The CBNT M03 is connected to the AC power source by a NEMA power cord on all
North American installations. The customer (or local StorageTek office) is to provide the
power connector for all International installations.
The cabinet's power distribution unit (PDU) supplies AC power to the installed devices.
The following lists the feature codes and part numbers for the cabinet’s power cords.
Table 3 AC Power Cords
Feature Description Attach-end Picture
9955 North American standard three-prong 220
VAC (NEMA L6-30P) to IEC-309-332P6 type
9954 International (connector ready) type
Note: Three ready-to-be-attached stranded-
copper wires are available to
connect via qualified personnel.
BROWN