124
Monitor display and monitor output signal
4.11.5 How to calibrate the terminal FM when using the operation panel
Follow the following procedure to calibrate terminal FM using the operation panel.
Refer to page 123 for the details of parameters.
Operation Display
1. Confirm the operation status indicator and
operation mode indicator
(When Pr. 54 = 1)
2. Press to choose the parameter setting
mode.
PRM indicator is lit.
(The parameter number read previously appears.)
3. Turn until appears.
4. Press to read the present set value.
" " (initial value) appears.
5. Turn to change it to the setting value of
"".
6. Press to set.
Flicker...Parameter setting complete!!
7. Turn until appears.
8. Press to display .
9. Turn until appears.
Set to C0 FM terminal calibration.
10.Press to enable setting.
11.If the drive unit is at a stop, press the
key to start the drive unit.
(Motor needs not be connected.)
12.Turn to adjust the indicator needle to
the desired position.
Analog indicator
13.Press .
Setting is complete.
Flicker...Parameter setting complete!!
Turn to read another parameter.
Press to return to the indication (step 4).
Press twice to show the next parameter ( ).
C1 to C7 setting
is enabled.
The monitor set to Pr. 54
FM terminal function selection
is displayed.
