Parameter listParameter list
64
4
PARAMETERS
Parameter List
Clear parameters
Pr.CL
Parameter clear 0, 1 1 0
230
Pr.CL
— FC — — — —
ALLC
All parameter clear 0, 1 1 0
230
ALLC
— FC —— — —
Er.CL
Faults history clear 0, 1 1 0
232
Er.CL
— F4 — — — —
—
Pr.CH
Initial value change list — — —
231
Pr.CH
——— — — —
—
AUTO
Automatic parameter setting — — —
222
AUTO
— — — — — —
∗1 Differ according to capacities. (0.2K to 2.2K/3.7K)
∗2 The parameter number in parentheses is the one for use with the parameter unit (FR-PU07).
∗3 Write is disabled in the communication mode (Network operation mode) from the PU connector.
∗4 These parameters are communication parameters that are not cleared when parameter clear (all clear) is executed from RS-485 communication. (Refer to
page 167 for RS-485 communication)
REMARKS
y The unit for parameter setting and its setting range can be changed from "r/min" to "Hz". Use Pr.144 to change the setting.
y With operation panel, the value up to 9999 can be set. With parameter unit (FR-PU07), up to the highest value in the setting
range can be set.
y A value exceeding 3000r/min can be also set, but the actual operation will be limited at 3000r/min, which is the upper speed
limit of the motor.
Function
Parameter
Name Setting Range
Minimum
Setting
Increments
Initial
Value
Refer
to
Page
Customer
Setting
Parameter Remarks
Instruction Code Parameter
Read Write
Extended
Copy Clear All clear
