Page 17 - 14 Xerox Document Centre System Administration Guide
6. The Print Service name entered at the UI should match the
name of the Print Service created at the Server.
7. PCPRINT is the Destination configured for the Print Service
at the Server.
8. If any changes are made at the User Interface the printer will
reset.
9. Allow the printer approximately seven minutes to reboot.
10. Print out another Configuration Report page to verify the
items you modified were set and retained.
11. Consult the table below for troubleshooting suggestions.
Printer busy Job reached the
top of the queue and cannot
print.
Check steps 3,4,5 above are
Correct. Check the PC port
setup with the SETPRINT
command.
Paper Format NA Job reached the top of the
queue and an attempt to match
the job format failed. Change
either the jobs format or the
format of the destination
printer to print the job.
Rejected Job is corrupted, or an internal
occurred. Check or reinstall
print drivers.
Cancelled Job was removed from the
queue. The queue configured
timeout expired. Check queue
configuration.
