Xerox Document Centre System Administration Guide Page 2 - 5
2. How to Connect to
Ethernet or Token
2. How to Connect to
Ethernet or Token Ring
How to set the Hardware (MAC) Address
All Document Centre printers equipped with a Token Ring
interface have a default MAC address. It is STRONGLY
recommended that you use caution when changing the MAC
Address of the network interface.
1. Access the Tools pathway.
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current password. Press
the Enter button when finished. The Touch Screen will
be used for the remainder of the data entry, unless
instructed otherwise.
c) Press the Go to Tools button.
2. Set or Change the MAC address.
a) Wait for the screen to refresh and press the Connectivity
and Network Setup button.
b) Wait for the screen to refresh and press the Physical
Media button.
c) Press the Token Ring button.
d) Press the Token Ring Settings button.
e) Press the MAC Address button.
f) Enter the six (6) hexadecimal pairs on the touch keypad
separated by colons.
g) When finished press Save.
h) Press the Exit Tools button.
3. Wait a MINIMUM of 7 minutes for the printer to reset. The
Network Controller is being reset and initializing with the
new setup. When complete a Configuration Report will print.
a) Obtain the Configuration Report page from your
printer and verify that your Token Ring Settings have
been retained.
4. Connect your Document Centre to the network with the
appropriate cabling.
