Page 19 - 2 Xerox Document Centre System Administration Guide
FAX Installation for FTP
Before You Start
NOTE Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot.
Your Document Centre and your network Fax Server/software
solution must be connected to a network which has the TCP/IP
protocol enabled. Additionally, record TCP/IP information such as
Hostname, TCP/IP Address, and Default Gateway for both the
network Fax Server solution and your Document Centre.
It is strongly recommended your network Fax Server is assigned a
static IP address. If necessary, refer to the Static (Manual)
TCP/IP Addressing Quick Install Card contained in this card set
to configure your Document Centre in this manner.
Dynamic IP Addressing may be used for the network Fax
Server/software solution provided the DHCP server has been
configured with sufficient lease time so that the server normal
maintenance and service down times will not result in a change in
TCP/IP address.
An account must be created on the server to which the Document
Centre will FTP the fax documents that has sufficient rights or
permissions to allow the Document Centre to read files, write files,
delete files, and create new directories. Anonymous FTP logins will
not allow these rights. Record the login name, home directory, and
password of this account for use during this procedure.
