Filter
Top Products
84
User's Guide HDSP System Multiface II © RME
35.2 Connector Pinouts
TRS jacks of analog input / output
The stereo ¼" TRS jacks of the analog inputs and outputs are wired according to international
standards:
Tip = + (hot)
Ring = – (cold)
Sleeve = GND
The servo balanced input and output circuitry allows to use monaural TS jacks (unbalanced)
with no loss in level. This is the same as when using a TRS-jack with ring connected to ground.
TRS Phones jack
The analog monitor output on the
front is accessible through a stereo
¼" TRS jack. This allows a direct
connection of headphones. In case
the output should operate as Line
output, an adapter TRS plug to RCA
phono plugs, or TRS plug to TS plugs
is required.
The pin assignment follows interna-
tional standards. The left channel is
connected to the tip, the right channel
to the ring of the TRS jack/plug.