Filter
Top Products
Display Controller Installation
24
Figure 2: Examples of PCI slots
Installation Procedure
The following instructions will take you step by step through the
installation of the display controller(s) for your B
ARCO NIO FUSION
Display System.
1. If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
2. Turn off the computer, display(s), and other peripheral devices.
3. Unplug the computer’s power cord and disconnect all cables
from the back of your computer.
4. Remove the computer cover.
If necessary, consult your computer’s manual for help in
removing the cover.
CAUTION – Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
Caution – Wait approximately 20 seconds after unplugging
the power cord before disconnecting a peripheral or
removing a component from the motherboard to avoid
possible damage to the motherboard.