Filter
Top Products
Connecting the signal cables
39
Connecting the signal cables
To connect the signal cables to the display:
1. Unpack the display and put it on a solid flat surface.
2. Make sure the computer is turned off.
3. To get access to the connectors, remove the connector
compartment cover (1).
To remove the cover, gently pull one side of the cover backward
to put the cover clips under stress. Then one by one, starting at
the side where you are pulling, release the 4 cover clips by
pressing with the other hand on top of the cover where the clips
are located (see drawing below).
4. To facilitate cable routing afterwards, remove the display stand
neck cover (2). Therefore, first tilt the display panel in upright
position. Then lift and pull backward the neck cover.
5. Also to facilitate cable routing afterwards, open both cable duct
covers (3).
Figure 12: Remove covers before connecting signal cables
1
2
3