Filter
Top Products
Basic
Operations
Note:
• Be
sure to read this chapter referring to the front
diagrams
of
chapter
"3.
CONTROLS"on page
6.
Lower
the
volume
level before
powering
the
source
unit
off. The
source
unit
stores
the
last
volume
setting.
If
the
source
unit
is
powered
off
with
the
volume
up, when
the
source
unit
is
powered
back
on,
the
sudden
loud
volume
may
harm
your
hearing
and/or
damage
the
source
unit.
A WARNING
When
the
front
panel
is
open,
no
sound
is
produced,
and
source
unit
controls
and
remote
control
unit
operations
are
disabled.
Always
shut
the
front
panel
after
changing
the
CD.
EXPOSING THE UNITTOWATER WITH THE
FRONT PANEL OPEN WILL CAUSE
DAMAGE OR UNIT MALFUNCTIONl
Turning
on/off
the
power
1.
Press the [POWER] button.
2.
The illumination and display
on
the unit light
up.
The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3.
Press the [POWER] button to turn off the
power for the unit.
Note:
• System check
During the initial
power
up
of
this unit, it will
go
through a system check procedure. This
procedure verifies
any
devices connectedthrough
GeNET.
Any
additional GeNETdevices plugged
into the unitafterthe initial
power
up will initiate the
system checkprocedure. The system checkstarts
automatically within the unit.
Selecting
a
mode
Press the [DISC], [SAT], [AM/FM] or [AUX]
button to change the operation mode.
* External equipment not connected with CeNET is
not displayed.
Adjusting
the volume
Turning the [VOLUME] knob clockwise increases
the volume; turning it counterclockwise
decreases the volume.
* The volume level is from 0 (minimum) to 33
(maximum).
Switching
the
display
Press the [DISP] button to select the desired
display.
The display changes each time you press the
[DISP] button.
* The display status varies depending on the mode
you selected. For more information, refer to
chapters of the each operation mode.
Adjusting
the
bass
Turning the [BASS] knob clockwise emphasizes
the bass; turning
it
counterclockwise attenuates
the bass.
* Adjustment range:
-8
to +8 dB
Adjusting
the treble
Turning the [TREBLE] knob clockwise
emphasizes the treble; turning it
counterclockwise attenuates the treble.
* Adjustment range:
-7
to +7 dB
Adjusting
the fader
Turning the [FADE] knob clockwise emphasizes
the sound from the front speakers; turning
it
counterclockwise emphasizes the sound from
the rear speakers. The fader adjusts both the
source unit RCA and speaker outputs.
* Adjustment range: F12 (full front) to R12 (full rear)
14
CM05