Filter
Top Products
If
an
error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
A DISC
is
caught inside
the CD deck and is not
ejected.
A DISC cannot be played
due to scratches, etc.
A DISC is loaded upside-
down inside the CD deck
and does not play.
A communication error
occu
rs
between the iPod
and the iPod CeNET
Controller.
A CD inside the CD
changer
is
not loaded.
ACD
inside the CD
changercannotbe played
due to scratches, etc.
A CD inside the CD
changercannot be played
because it is loaded
upside-down.
The speaker protection
circuit
is
operating.
During this operation, if
any volume operation is
performed, the display
shows "AMP GUARD".
"AMP GUARD"
sometimes functions
when special test signals
are used.
This is a failure of CD deck's mechanism and
consult your store of purchase.
Replace with a non-scratched, non-warped-disc.
Eject the disc then reload it properly.
Disconnect the iPod, then connect it again.
This
is
a failure of CD changer's mechanism.
Consult your store of purchase.
Replace with a non-scratched, non-warped disc.
Eject the disc, then reload it properly.
1.
Turn down sound volume. Function can also
be restored by turning the power off and on
again.
(Speaker volume
is
reduced automatically
when the speaker protection circuit operates.)
2.
If the sound
is
muted again, consult our
service department.
If
an
error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
CMD5
35