Filter
Top Products
Common Operations
AUX
function
.This system has rear RCA cables so you can
listen to sounds and music from an external
device connected to this unit.
Cellular telephone mute
This unit requires special wiring to mutethe audio
signal automatically when a cellular telephone
rings.
* This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information
on
proper installation and
compatibility.
Changing the adjustment setting
1.
Press the [MENU] button to switch to the
adjustment selection display.
2.
Press the
[!]
or
[T]
button to select the
adjustment item.
Each time you press the
[!]
or
[T]
button, the
adjustment item changes as following order:
"DIMMER"
~
"CLOCK"
~
"LOUD"
~
"NF
VOL"
~
'IS~D
D~SP'1
""\~~
,ITVlVTR"
'\\IU~-
"T\l
.1~~~lE.it\"
<III\\I1\\'-
"TV
D~VER'l
,\\1\\1),
"AUX SENS
l
'
~
"CONTRAST"
~
"SCROLL"
~
"A-CANCEL"
~
"TEL-SEL"
~
"TEL-SP"
~
"TEL-SW"
~
"RESET"
~
"SYSTEM CHECK"
~
"DIMMER"
...
3.
Turn the [VOLUME] knob to adjust the
selected setting.
* When "ENT" is blinking
on
the display, press
the [ENT] button to adjust the setting value.
4.
After. the adjustment is complete, press the
[MENU] button to return to the previous mode.
Notes:
• The adjustment setting is canceled when
not
operating formore than 10 seconds (except Clock
and
Sirius
10
setting).
• When each mode is selected, the item shown in
grey will be displayed.
Dimmer Control
You can set the dimmer control.
* The factory default setting
is
"OFF".
1.
Press
the
[MENU] button to switch to the
menu mode.
2.
Press the
[!]
or
[T]
button to select
"DIMMER".
3.
Turn the [VOLUME] knob to select "ON" or
"OFF".
4.
Press the [MENU] button to return to the
previous mode.
Setting the clock
1.
Press the [MENU] button to switch to the
menu mode.
2.
Press the
[!]
or
[T]
button to select "CLOCK".
3.
Press the [ENT] button.
4.
Press the
[!]
or
[T]
button to select the hour
or the minute.
5.
Turn the [VOLUME] knob to set the correct
time.
* The clock is displayed
in
12-hour format.
6.
Press the [ENT] button to store the time into
memory.
7.
Press the [MENU] button to return to the
previous mode.
Note:
•
You
cannot setthe clock when it is displayed with
only the ignition
on.
If
you drain
or
remove the
boars
battery
or
take out this unit, the clock is
reset. While setting the clock,
if
anotherbutton
or
operation is selected, the clock setmode is
canceled.
Setting the loudness
* The factory default setting
is
"ON".
1.
Press the
[MENU]
button to switch to the
menu mode.
2.
Press the
[!]
or
[T]
button to select "LOUD".
3.
Turn the [VOLUME] knob to select "ON" or
"OFF".
4.
Press the [MENU] button to return to the
previous mode.
CMD5
21